Robot Vacuum & Mop Floor Cleaning Solution for Pet Homes

It’s boosted for paw oil, drool protein, and pet odor and is unscented and just as low-foam.

Dilute it 1:50–1:100, keep pets off the floor while the robot mops and until it's fully dry, then let them walk and lie on it. Cap the concentrate and keep it where pets can't lick it.

Don’t let it; it spreads the mess and fouls the pad. Clean up by hand, treat with the Pet Odor Eliminator, then let the robot mop.

Don't. Vinegar is acidic and, used regularly, can wear rubber seals and etch marble and other natural stone floors. Bleach can corrode metal parts, discolor floors, and must never be mixed with other cleaners. Essential oils don't dissolve in water; they coat the lines and pads with an oily film and can swell rubber parts. For a stronger clean, use a low-foam robot solution at the labeled dilution.

No. Add the solution only to the clean-water tank or the dock's detergent compartment. The dirty-water tank just collects wastewater; empty, rinse, and air-dry it after each run to keep odors down.

Very little at the labeled dose. Overdosing or mixing with other cleaners can cause foam. If you see foam in the tank, empty it, rinse with clean water, and refill at the right ratio.

Hair is handled by the brushes and bin, not the solution. With heavy shedding, vacuum or let the robot sweep first, then mop with the solution, and clear hair from the pads and brush roll after each run.

At 1:50–1:100, add 10–20 mL per liter of water; 1 L of solution treats 50–100 L of water, or about 50–100 fills of a 1 L tank. Most dock clean-water tanks hold about 1 L, so that's 10–20 mL per fill; scale up for a larger tank (a 3–4 L tank needs three to four times as much) and down for a smaller one. Another brand's 1:200 doesn't apply here, so follow this label, and with several pets add the normal dose every time, running extra passes on dirty zones instead of doubling.

It contains no quaternary ammonium compounds (quats) or phenols, the two disinfectant groups most often named in online concerns about cats licking floors, and the pet version has no fragrance. Still, dilute it at 1:50–1:100, let the floor dry before cats and dogs walk or lie on it, and keep the capped concentrate where pets can't lick it. If your cat has kidney disease or another health condition, ask your vet first.

The robot handles it day to day. Pick up dried, crusted food with a paper towel first so it doesn’t get smeared across the floor.

Yes. It's been tested on common models such as Roborock, Roomba, Ecovacs, Dreame, Narwal, and Tineco, with no foam, residue, or water-line issues. Add 10–20 mL to the clean-water tank or the dock's detergent compartment, never the dirty-water tank. If your manual requires the brand's own solution, follow the manual.

Warranty terms vary by brand, and some manuals ask for the brand's own solution, so check yours or ask the brand during the warranty period. Brands mainly worry about foam clogging water lines and ingredients wearing seals. This low-foam, pH-neutral (7.0–8.5) concentrate is made to avoid both when used at the labeled dilution.

It's a daily floor cleaner for paw prints, drool marks, and pet odor, and makes no germ-kill claims. Clean up urine and vomit by hand first; where disinfection is needed, use a registered disinfectant labeled for pet areas, per its label.

Cats and dogs smell far more keenly than we do, and added fragrance can bother them, so the pet version has no fragrance. Cyclodextrin-type odor neutralizers trap and carry pet odor away instead of masking it. To check, smell the spots where your pets lie and walk once the floor is dry; no urine or drool smell means it's handled. A lingering smell usually means urine has soaked into seams, which needs spot treatment before the robot mops.

Water lifts loose dust, but footprints, skin oils, and greasy film tracked from the kitchen just smear. The solution loosens that film and light soil, so the difference shows as floors that don't feel tacky and show no mop streaks in raking light, not as a dramatic change. On floors that are already clean, the difference is small; it's most noticeable on greasy footprints, kitchens, and entryways. Keep to the labeled dose rather than cutting it.

Decide the pet focus (cats, dogs, or both), scent (unscented by default, custom scents available), bottle, and whether to launch alongside the standard version. Formula direction, fill size (such as a 1 L concentrate or dock-compatible refills), measuring cap, label design and language, and bundles with the Pet Odor Eliminator can all be customized.

Free samples are usually ready in 3–5 days, and we recommend testing first: try them on floor panels with muddy paw prints and drool and record removal, odor, foam, and slip after mopping. Standard MOQ is 500 bottles, and bulk orders are scheduled after packaging and labels are approved. SDS/MSDS, a TDS, batch COAs, and bilingual label content are sent per project on inquiry.

Pricing is tiered by packaging, cap, label, and order quantity, starting at the 500-bottle MOQ. Send your target quantity, fill size, and packaging needs, and we’ll quote unit prices by volume tier with sample and lead-time details.